Pin-Layouts Mouse Interface (c) 1991/1997 THOR Hardware (Thomas Richter)
________________________________________________________________________

EMail:  thor@math.tu-berlin.de



Amiga mouse
--------------------------------------------------------

pin 1           VP              Vertical        Pulse
pin 2           HP              Horizontal      Pulse
pin 3           VQ              Vertical        Qualifier
pin 4           HQ              Horizontal      Qualifier
pin 5           MB              Mouse Middle    Button
pin 6           LB              Mouse Left      Button
pin 7           Vcc             +5 Volts Power (125 mA)
pin 8           GND             Ground
pin 9           RB              Mouse Right     Button

Standard 9 pin sub-D


Atari Joystick connector
-------------------------------------------------------

pin 1           PA0=FWD         Joystick Forward
pin 2           PA1=BACK        Joystick Back
pin 3           PA2=LEFT        Joystick Left
pin 4           PA3=RIGHT       Joystick Right
pin 5           PDL_B           Potentiometer B Input
pin 6           TRIG0           Trigger Input
pin 7           +5V             +5 Volts Power
pin 8           GND             Ground
pin 9           PDL_A           Potentionmeter A Input



CD 4021B 8 Bit Shift Register With Parallel Load
--------------------------------------------------------

pin 1           P7              Input Bit 7
pin 2           Q5              Output Bit 5
pin 3           Q7              Output Bit 7
pin 4           P3              Input Bit 3
pin 5           P2              Input Bit 2
pin 6           P1              Input Bit 1
pin 7           P0              Input Bit 0
pin 8           GND             Ground
pin 9           LOAD            Parallel Load
pin 10          CLK             Clock
pin 11          IN              Serial IN
pin 12          Q6              Output Bit 6
pin 13          P4              Input Bit 4
pin 14          P5              Input Bit 5
pin 15          P6              Input Bit 6
pin 16          Vcc             Supply Voltage


CD 4030B Quadrupel EXOR Gates
--------------------------------------------------------

pin 1           A0              Input A Gate 0
pin 2           B0              Input B Gate 0
pin 3           Q0              Output Gate 0
pin 4           Q1              Output Gate 1
pin 5           A1              Input A Gate 1
pin 6           B1              Input B Gate 1
pin 7           GND             Ground
pin 8           B2              Input B Gate 2
pin 9           A2              Input A Gate 2
pin 10          Q2              Output Gate 2
pin 11          Q3              Output Gate 3
pin 12          B3              Input B Gate 3
pin 13          A3              Input A Gate 3
pin 14          Vcc             Supply Voltage


CD 4516B Synchronous Programmable Binary Counter
--------------------------------------------------------

pin 1           LD              Parallel Load
pin 2           Q3              Output Bit 3
pin 3           P3              Input Bit 3
pin 4           P0              Input Bit 0
pin 5           CI_             Carry In (inverted)
pin 6           Q0              Output Bit 0
pin 7           CO_             Carry Out (inverted)
pin 8           GND             Ground
pin 9           RS              Reset
pin 10          U/D_            Up/Down selector
pin 11          Q1              Output Bit 1
pin 12          P1              Input Bit 1
pin 13          P2              Input Bit 2
pin 14          Q2              Output Bit 2
pin 15          CLK             Clock Input
pin 16          Vcc             Supply Voltage


Note: CMOS circuits are sensitive to static electricity! Please keep grounded
when soldering! Unlike TTL circuits CMOS inputs MUST NOT left open, they MUST
be connected to ground.