1 Atmega8-16pu cpu                     D/K ATMEGA8-16PU-ND 
1 IC socket  28 pin x .3               D/K AE10286-ND
1 Crystal  14.31818 mHz                D/K X091-ND
1 LE33ca voltage regulator             D/K 497-4258-1-ND
1 1N914(1N4148) diode                  
1 Atari SIO Jack /cable half           Best Electronics, B&C
1 Dip Switch, 4 pos  (right angle)     D/K CKN6140-ND 
1 LED red  T1 3/4, 20ma           
1 LED green  T1 3/4, 20ma 
4 LED yellow  T1 3/4, 20ma 
1 Tantalum capacitor 10uf 10-16v #106  D/K 718-1421-1-ND
2 Disc capacitor 22pf 10-16v   #220    D/K 1429PH-ND
2 Disc capacitor 100nf 10-16v  #104    D/K 478-3193-ND
1 Disc capacitor 1uf 10-16v  #105      D/K 478-4864-ND
4 Disc capacitor 22nf 10-16v  #223     D/K 478-3181-ND
3 Resistor 1/4W 1.8K                   D/K 1.8KQBK-ND
1 Resistor 1/4W 47K                    D/K 47KQBK-ND
3 Resistor 1/4W 3.3k                   D/K  3.3KQBK-ND
6 Resistor 1/4W 1.5k                   D/K  1.5KQBK-ND
1 header .1 x 6 pins      (programming)
          
4 PB Switches(many types can be used), its up to you..
   NOTE: For mounting to either side, but, if you mount on 
   component side, pins will need an extension. 
  D/K 401-1974-ND Yellow
  D/K 401-1977-ND Blue
  D/K 401-1975-ND Red
  D/K 401-1976-ND Green
  D/K 401-1976-ND Black
16 Extension pins for Lg buttons   
or
4 Small type pb....NOTE: For mounting either side, but on 
   component side, pins will need reinforcing/extending.
  such as D/K P8077SCT-ND

1 SD Connector **SURFACE MOUNT**       D/K HR846CT-ND
   NOTE:This is the reverse version.  It can go on the
   foil side of the pcb, or attached to the foil side 
   of a daughter board(face down), then soldered through
   the component side of the main pcb with a header strip.
1 header .1 x 12 pins     (sd card mount)